Expert Drywall Repair in Batesville, MS

Most standard drywall patches in Batesville run $350–$500 for small holes under six inches, and $500–$900 for medium repairs requiring backing and texture matching. Water damage repairs are scoped after a moisture inspection because the hidden damage often extends well past the visible stain. TAV Construction provides free, no-obligation estimates for all Batesville and Panola County homes — call or submit the form and we'll come take a look before quoting anything.

The right approach is to fix the source of the leak first — patching over wet or damp drywall will just fail again within months. Once the leak is resolved, we cut out the damaged material at least 12 inches past the visible stain line to reach dry substrate, let the framing and cavity fully dry out, then install mold-resistant gypsum board before taping and finishing. Skipping the drying stage or cutting too close to the damage are the two most common reasons water damage repairs fail.

Yes — every repair we do is finished paint-ready as standard, meaning primed and ready for your painter without any additional prep. For projects requiring Level 5 finishing — skim-coat over the entire surface for high-gloss or sidelighted applications — we can bring walls up to that standard as well. We don't hand off a rough patch and call it done; the primer coat is included so your painter gets a uniform, non-flashing surface.

Small hole repairs — doorknob punches, nail pops, hairline cracks — are often completed in a single day including texture and prime. Larger repairs involving backing installation and water damage cut-outs typically require 2–3 days to allow each coat of joint compound to fully dry before the next is applied. Rushing the mud coats is the primary reason patches crack or telegraph back through paint within a year — we build in proper dry time rather than cutting corners.

Texture matching is a core part of every repair we do — it's included in the quote, not a separate line item. We work with knockdown, orange peel, popcorn, skip trowel, and smooth finishes common in Batesville and Panola County homes. For older homes with hand-applied textures, we test the match on a small area before finishing the full patch so you can approve the result before we move on.

Hanging is the physical installation of gypsum board — cutting panels to size, attaching them to studs, and fitting them around openings. Finishing is the skilled trades work that follows: taping seams, applying multiple coats of joint compound, sanding, and priming. Most homeowners only call for finishing repairs on existing walls, but if you have a room addition, garage conversion, or remodel underway, TAV Construction handles both phases so there's one crew and one standard of quality throughout.

Joint compound sanding produces very fine dust that can spread through an entire house if not contained. We use dust-containment systems — negative pressure where appropriate, plastic barrier sheeting over doorways, and full floor protection throughout the work area. Daily cleanup is part of our process, not an afterthought. We also prime the patched area before leaving so there's no raw compound dust left to settle.

Nail pops are extremely common in North Mississippi due to the clay-heavy soil that shifts with seasonal moisture changes, and they're a straightforward fix when done correctly. We re-drive or replace the fastener, apply a screw above and below the pop to lock the board in place, then fill and feather the surface with compound before texturing and priming. A nail pop that's just mudded over without addressing the fastener will pop again — we fix the mechanical cause first.